The logic design of sequence circuit of welding supply based on gal 的焊接電源時序電路設計
The method of optimization is classified into two categories : ( 1 ) combinational optimization method , which is the optimizational method of combinational circuit is directly used for the sequence circuit 優化的方法大致可分為兩類: ( 1 )組合優化方法,即將組合電路的優化方法直接用于時序電路。
But circuitry net table which is synthesized by synthesizer is not necessarily achieve the demand of designer , so aim for the speed demand of destination , the sequence circuit which is synthesized demand speed optimization 但是由于綜合器綜合得到的電路網表不一定能達到設計者的設計要求,所以需針對給定的速度要求,對綜合得到的時序電路進行速度優化。
According to zero sequence voltage distribution from system zero sequence impedance to shunt reactor zero sequence in zero sequence circuit , the zero sequence voltage at the terminal of shunt reactor and the zero sequence compensating voltage at neutral are compared in the scheme 即根據零序網絡中零序電壓在系統零序阻抗和電抗器零序阻抗上的分布情況,通過直接比較電抗器首端零序電壓與補償?shù)诫娍蛊髂┒酥行渣c(diǎn)的零序補償電壓的幅值大小,來判別電抗器匝間故障。
Automatic water - measuring meter is the combinative production of traditional method and present cmos integration circuit technology . it consists of water - level sensor and mainframe circuit . on the basis of analyzing its application , this paper gives the design of mainframe circuit , including time circuit , time - sequence circuit , input - interface circuit , switch circuit and power circuit 本文在分析cmos集成電路應用的基礎上,給出了自動量水儀表主機電路的設計,包括定時電路、時序電路、輸入接口電路、開關電路和電源電路的設計;其次,對水位傳感器進行了研究,分析了水位傳感器的工作原理、測量使用條件、動態特性、靜態特性以及水位傳感器的率定、標定方法。
Waveform simu1ation is done in combinat ion circuit and sequence circuit for val idat ing if the method of expressing waveform by hdl is practicabi1ity . at the same time , for improving the speed of waveform s imu1at ion , some key problems and used ari thmet ic appeared in waveform simulation are exp1ained in detai 1 為了進一步地驗證硬件描述語言表達波形方法的有效性,結合組合電路和時序電路進行波形仿真,并對此過程中涉及的關鍵問題與相應的算法進行了詳細的論述。